http://pesn.com/2010/07/31/9501681_Revealing_What_I_Know_About_Building_the_Perendev_Magnet_Motor/
You are here: PureEnergySystems.com
> News > July 31, 2010
Revealing what I know about building the Perendev magnet motor > Photos
of Assembly
Having honored the NDA long after the term expired, given new
unsettling developments I now reveal blueprints, photos, and other insider
information in hopes that it might help the many people out there trying to
replicate Michael Brady's all-magnet motor.
The little plastic rods were used to hold the magnets in place in the rotor
and stator.
Though the rotor magnet holes were fully populated, the stator magnet holes
were not. There was a "timing trick" that Brady tried to convey,
but it didn't work for us while we where there.
The guy on the right is the one who, while sitting at the kitchen table with
us, looked me in the eye and very seriously said "Yes" when I asked
him if he had seen the motor running. He was one who put up quite a bit of
capital toward the project. Susan is sitting back in the corner.
Shipping Container for Motor
Brady had this built to transport the motor to the U.S. for the tour we were
planning for him.
Bismuth Mold (?)
I think these photos are of a mold Brady made to cast his bismuth shield that
went around each magnet.
What?!! I couldn't believe he was taking torch to one of his
rotors to try something out with a new shielding approach while we were
there. I chimed in and urged him to hold off.
Around
Johannesburg - including the machine shop we went to to pick up
the newly fabricated motor components (rotors and stators); neighbor
Nielson Mandela's home; opulence/poverty contrast; street vendors
Brady's
House - including a shot of the kitchen table I was sitting at
when a witness confirmed he had seen the motor running
History Snapshots
- of various iterations also tried and claimed to work
Aluminum
Version (pre-dated the polypropylene version seen in the video)
Perendev
Power -- First-Hand Report - Sterling D. Allan gives a history
of his interaction with Michael J. Brady over three years in process
of securing the North American rights to manufacture and market the
magnet motor. (FreeEnergyNews; March 18, 2004)
ADVISORY: With any
technology, you take a high risk to invest significant time or money
unless (1) independent testing has thoroughly corroborated the
technology, (2) the group involved has intellectual rights to the
technology, and (3) the group has the ability to make a success of
the endeavor.
All
truth passes through three stages:
First, it is ridiculed;
Second, it is violently opposed; and
Third, it is accepted as self-evident.
--
Arthur Schopenhauer (1788-1860)
"When you're one step ahead
of the crowd you're a genius.
When you're two steps ahead,
you're a crackpot."
Feed